General Maintenance, Cleaning - Agria 3600 BM Operating Instructions Manual

5. Maintenance
General Maintenance
Watch out for fuel and oil leakage,
repair if necessary.
Regularly check screws and nuts for
tight fit, re-tighten, if necessary.
Lubricate all gliding and moving parts
(e.g. speed control lever, bearings of
hand levers) with Bio-lubricating grease
or Bio-lubricating oil.
Cleaning
Cutter Bar
After each mowing operation, clean cut-
ter bar thoroughly with water. Above all,
remove dirt collected between knife
blades. For this purpose, dismount mow-
ing knife. After cleaning, oil or grease
all gliding parts with Bio-lubricating oil
or Bio-lubricating grease.
Mowing Drive and Machine
After cleaning with air-compressed wa-
ter jets immediately lubricate rocker arm
bearing on mowing drive and lubrica-
tion points on the machine and operate
mowing drive for a short time to press
out penetrated water. Apply grease gen-
erously to leave a grease neck around
bearing to prevent water, plant sap and
dirt from penetrating.
42
Engine
Clean engine only with a cloth. Avoid
spraying with water jets, as water might
penetrate into ignition and fuel system
and cause malfunctions.
Power Mower 3600 BM Edition 03.96