Notes On Internal Memory; Before Removing The Vehicle Battery; Data Subject To Erasure; Resetting The Microprocessor - Pioneer AVIC-8100NEX Operation Manual

Chapter
01 Introduction
"External storage device (USB, SD)"
The SD memory card, SDHC memory card
and USB memory device are collectively re-
ferred to as the "external storage device (USB,
SD)". If it indicates the USB memory only, it is
referred to as the "USB storage device".
"SD memory card"
The SD memory card and SDHC memory card
are collectively referred to as the "SD memory
card".
"iPod"
In this manual, iPod and iPhone will be re-
ferred to as "iPod".

Notes on internal memory

Before removing the vehicle
battery
If the battery is disconnected or discharged,
the memory will be erased and must be repro-
grammed.
p Some of the settings and recorded con-
tents will not be reset.

Data subject to erasure

The information is erased by disconnecting
the yellow lead from the battery (or removing
the battery itself).
p Some of the settings and recorded con-
tents will not be reset.

Resetting the microprocessor

CAUTION
Pressing the RESET button resets settings and re-
corded contents to the factory settings.
p Do not perform this operation when a device
is connected to this product.
p Some of the settings and recorded contents
will not be reset.
12
En
The microprocessor must be reset under the
following conditions:
! Prior to using this product for the first time
after installation.
! If this product fails to operate properly.
! If there appears to be problems with the op-
eration of the system.
! If your vehicle position is shown on the
map with a significant positioning error.
1 Turn the ignition switch OFF.
2 Press the RESET button with a pen tip
or other pointed implement.
Settings and recorded contents are reset to
the factory settings.
8100NEX 7100NEX
6100NEX 5100NEX
1
1 RESET button
1