Multi-Speed Plc Group:h00-H55(0X0300-0X0337) - Powtran PI8600 Series User Manual

Section V Parameter Function Table
1 bit: Timing mode
0 Boot time , timing of runnig and breaking
1 Running timing，only timing of running
10 bit：Reserved
100 bit：Reserved
1000 bit：Reserved
o67 Limit Time 1
o68 Limit Time 2
Set timeing of limit time 1 , Time limit 2
Actual limit time on the basis of the set time multiplied by a run time multiple, such time
multiple set by the ten bit of F49, refer to F49 instructions.

5-6 Multi-speed PLC Group:H00-H55(0x0300-0x0337)

Code Description / LCD
Multi-speed
H00
collocation
1 bit: Program running functions intelligent
To use the program to run PLC functionality requires setting the bit to 1.
Multi-segment speed run only need to set the corresponding multi-stage o36 ~ o46-speed
switching can be used without the need to set this parameter.
0: Program running functions cancel
1: Program running function intelligent
10 bit: Define program runs or direction settings of multi-segment speed running
0: the direction decided by the H40 ~ H46
1: The directiondecided by the keyboard or terminal
100 bit:Define program runs or acceleration and deceleration time settings of multi-segment
speed running
0: deceleration time decided by the H26 ~ H39
1: The acceleration and deceleration time determined by terminal
100bit Reserved
1000bit Reserved
0.0~3200.0
0.0~3200.0
Setting Range
Program running function
cancel
1 bit
Program running function
Direction decided by
H40~H46
10 bit
Direction decised by
terminal and keyboard
Deceleration and
acceleration time
decised by H26~H39
100 bit
Time of acceleration
and deceleration
isdecided by terminal
Running time decised
by H18~H25
1000bit
Running time decised
by terminal
70
-
-
s 2.0
s 2.0
Factory
Unit
Setting
0
1
0
1
- 0000
0
1
0
1
Y
Y
Change
Limited
Y