Installation - Hamamatsu Photonics C11440-22C Insctruction Manual

C11440-22C Instruction manual_Ver.1.4

3. INSTALLATION

Avoid using or storing this camera in the following places
Where the ambient temperature might fall below 0 °C or rise above 40 °C
•
Where the temperature varies extremely
•
In direct sunlight or near a heater
•
Where there is dripping water
•
Close to a strong source of magnetism or radio waves
•
Where there is vibration
•
Where it might come into contact with corrosive gases (such as chlorine or
•
fluorine)
Where there is a lot of dust
•
How to place the camera (when the camera is placed on a table)
Place the camera the water connectors to be lateral side.
Do not place the camera the rear panel of the camera, which connectors
are located, to be at the bottom. (Do not block ventilation openings.)
Do not block ventilation openings
To prevent overheating in the camera's interior, do not wrap the camera
in cloth or other material, or in any way allow the camera's ventilation
ports to become blocked. If the camera is being operated in an enclosed
environment, ensure clearance of at least 2 cm from both the intake and
exhaust vents when setting up.
Weight of the camera
Be careful not to drop off the camera or not drop underfoot when
making it move because it is approx. 2 kg.
6