Logic Switch Selection (Logic Sw) - RadioLink AT9 Instruction Manual

• MIX: When the TRAINER SWITCH is ON, the channel set to this mode can be controlled by both the
student and the instructor, controlled according to any mixing set at the instructor's transmitter. And the
student's mixing rate is adjustable. (Default 30%)
[Note] However, it becomes invalid even if it sets up the channel which is not in a student's transmitter. The
channel serves as operation by the instructor's transmitter automatically.
• OFF: The channel set to this mode cannot be controlled by the student even when the TRAINER
SWITCH is ON. The set channel is controlled by the instructor only, even when the TRAINER SWITCH is
ON.
• SWITCH: controlled by spring-loaded SWITCH H only. Not assignable.
• Compatibility: The AT10 may be master or student with any Radiolink transmitter compatible with the
cord. Simply plug the optional trainer cord (For AT10 series, sold separately) into the trainer connection on
each transmitter, and follow the guidelines below.
EXAMPLES:
•When throttle/collective are set to FUNG, 5-channel helicopter practice is possible with a 4-channel
transmitter.
• Set up the model in a second transmitter, use NORM mode to quickly and safely check proper operation
of all functions, then allow the student radio to fully fly the model.
• Using NORM mode, set lower throws, different exponentials, even different auxiliary channel settings on
the student radio (if it has these features).
• To ease the learning curve, elevator and aileron may be set to the NORM or FUNC mode, with the other
channels set to OFF and controlled by the instructor.
NOTE:
• NEVER turn on the student transmitter power.
•ALWAYS set the student transmitter modulation mode to PPM.
• BE SURE that the student and instructor transmitters have identical trim settings and control motions.
Verify by switching back and forth while moving the control sticks.
• FULLY extend the instructor's antenna. Collapse the student's antenna. (except 2.4GHz)
• When the TRAINER function is active, the snap roll function is deactivated. Other functions, such as
IDLE-DOWN and THR-CUT, which have been assigned to the same switch, are not deactivated. Always
double check your function assignments prior to utilizing the TRAINER function.
•When you select a different model, the TRAINER function is deactivated in the current model for safety
reasons.
Goals
Turn on the TAINER
systemand set uo so student
has :fully functional control of
aileron and elevator to support
FLAPERON &AILERON;
normally control of rudder to
allow lowered travel; and no
throttle channel control(with
the instructor for safety)

2.3.14 Logic Switch Selection (LOGIC SW):

The various functions in the AT9 can be selected by switch..
The Logic switch can be assigned to the following functions:
THR-CUT, IDLE DOWN,
AILE-FLAP functions. The logic switch can activate functions by two switches combination. The 2 types of
logic, either AND or OR, can be selected.
Steps
Open BASIC menu, then Open
TRAINER
Activate TRAINER
Choose desired channels and
proper training types
Close
Test student radio function prior to attempting to fly!
AUX-CH, TIMER, PROG. MIX, AIRBRAKE, ELEV-FLAP,
30
Inputs
for 1s .(If ADVANCE
to TRAINER ,PUSH
PUSH, to PUSH
past AIL and ELE(default FUN)
to THR,PUSH，
to RUD, PUSH, to NORM,PUSH
again) .
to OFF, PUSH
and