Changing The Netmask - AGFA Drystar 5302 Reference Manual

Changing the netmask

Perform steps 1 to 2 of the
1
page 68.
On the Change settings menu, press the Down key three times, followed by the
2
Confirm key to select 'Network (DICOM)'.
The 'Network (DICOM)' screen is displayed:
5 Netmask
6 Router IP-address
7 Remove modality
8 Add modality
On the 'Network (DICOM)' screen, press the Down key four times, followed by
3
the Confirm key to select 'Netmask'.
The 'Netmask' screen is displayed:
250.250.250.250
If the netmask has already been assigned, it will be shown on the display.
When no DHCP server is available and when the subnet mask of the printer has
never been set, the printer subnet mask will be set to the APIPA address
255.255.0.0.
Enter the netmask by means of the arrow keys. Refer to
4
Note that blank spaces will be ignored (see example).
Example: if the netmask is 250.250.250.0, then the data entry should be as follows:
250.250.250.
Press the Confirm key to store the data, or the Escape key to quit the procedure
5
without any changes.
2830A EN 20050526
'Accessing the Change settings menu'
0
D 5302 R
RYSTAR EFERENCE MANUAL
procedure on
'Data entry' on page 31.
Advanced operation (Key-operator mode)
83