Installation - AGFA Drystar 5302 Reference Manual

Installation

Two installation operations are possible:
•
install new software, or upgrade existing software from a CF-card,
•
perform a complete installation procedure, using the printer installation
wizard.
Installing new or upgrading existing software
It is possible to install new software or new software components.
Different software (components) can be installed:
•
language files,
•
modality specific files,
•
LUT,
•
calibration files,
•
...
The new software will be activated after the installation procedure (this may
require a reset operation). The previously installed software components will
be automatically removed when installing new software or new data. A copy
of the previous configuration is saved (as a dataset) on the hard disk.
Press the Key-operator key to enter the key-operator mode.
1
On the key-operator main menu, press the Down key eight times, followed by
2
the Confirm key to select 'Installation'.
The 'Installation' screen will be displayed:
2830A EN 20050526
D 5302 R
RYSTAR EFERENCE MANUAL
Advanced operation (Key-operator mode)
137