Related Manuals for CTC Union Skywave
Summary of Contents for CTC Union Skywave
- Page 2 Insert the connector of the power cord that is attached to the power supply into the power jack on the SOMAport.
- Page 3 Insert the Socket end of the AC power cord into the power supply. Insert the plug end of the AC power cord into a power outlet. The light on the front of the SOMAport turns green before you begin connecting your computer to the SOMAport.
- Page 4 Using your Ethernet cord, insert one end of the Ethernet cable into the Ethernet port on the SOMAport. Ethernet port lights: GREEN Light- The computer is connected AMBER Light- Data is being transmitted...
- Page 5 Insert the other end of the Ethernet cable into the Ethernet port on your computer, or your wireless router.
- Page 6 CTC phone service required, where available. OPTIONAL For connecting a telephone (1 phone only) 1) Insert the phone cord into the bottom phone jack . 2) Pick up handset and listen for dial tone. a. If you hear a series of tones (not dial tone), the SOMAport is stillbooting up.
- Page 7 SkyWave phone service you can select one of the following options: a. You can disconnect from your wired carrier from your demarcation point. b. You can call a CTC technician to install SkyWave to all phone jacks within your house. (Includes a one time tripcharge of $65) c.
- Page 8 911 Name, Telephone Number & Address will be registered to the address on address, the 911 information on record with local authorities will be inaccurate. CTC is not responsible for 911 record information when using SkyWave Voice that has been removed from the customer address on record. It is the customer’s...
-
Page 9: Choose The Best Location
Choose the best location Although the SOMAport’s internal antenna is self-steering, you can optimize signal reception by following these recommendations when choosing a location: • Allow at least 18 inches of space around the SOMAport. the basement. • Place the SOMAport higher up in a room. For example on a •... - Page 10 Enjoy!
- Page 11 Getting to know the Skywave Status Light SOMAport is not plugged in. AMBER SOMAport is booting up FLASHING AMBER GREEN SOMAport is powered and running normally An error occurred, unplug power cord and plug back in. If red light stays contact...
- Page 12 Getting to know the Skywave Network Light SOMAport is not plugged in AMBER FLASHING AMBER FLASHING GREEN SOMAport is attempting to establish a connection GREEN Connection has been established An error occurred, unplug power cord and plug back in. If red light stays contact...
Need help?
Do you have a question about the Skywave and is the answer not in the manual?
Questions and answers