Power Cable Connection; Switching On - Physis Piano H1 User Manual

3.3 POWER CABLE CONNECTION

1.
Make sure that the [POWER] switch is set as 0.
2.
Insert the female cable connector in the [AC-IN] port on the rear
panel.
3.
Plug the other end of the cable to a socket.
WARNING!
•
Always make sure to use earthed sockets.
•
Only use the power cable provided with the instrument.
•
If the instrument is to be out of use for lengthy periods, disconnect the plug from the power socket.

3.4 SWITCHING ON

1.
First, operate all the necessary connection. Then, press the [POWER] switch on the rear panel (see previous picture).
NB
Because of the complexity and power of the instrument, the switching on phase takes some time. Please wait until the
system is completely loaded.
2.
When switched on, Physis Piano will automatically select the acoustic piano physical model Sound (if the Last
Selection function is set as Off, see par.11.3).
3.
Use the [VOLUME] Key Touch located on the left to set the general volume.
You can also touch the
Key Touch bar on the
desired position
MIN V O L U M E MAX
EN - 7
User Manual – Switching on and connections
[VOLUME]
Key Touch
or slide your finger on the
surface for a continuous
volume control
[POWER] [AC-IN]
switch port
MIN V O L U M E MAX