Io-Area Connectors; Display Connectors (Io Area); Analogue Vga (Vga) - Kontron KTQ67/ATXE User Manual

KTD-N0829-G

5 IO-Area Connectors

5.1 Display connectors (IO Area)

The KTQ67 family provides one on-board Analogue VGA port, two on-board DP's (DisplayPort) and
optionally one on-board LVDS panel interface. Two graphic pipes are supported; meaning that up to two
independent displays can be implemented using any two of the above mentioned graphic ports.
.

5.1.1 Analogue VGA (VGA)

Pull
Note Ioh/Iol Type
U/D
/75R -
/75R -
/75R -
- -
- - PWR
Note 1: The +5V supply is fused by a 1.1A resettable fuse
Signal Description - VGA Connector:
Pin Signal Description
1 RED Analogue output carrying the red colour values. (75 Ohm cable impedance).
2 GREEN Analogue output carrying the green colour values. (75 Ohm cable impedance).
3 BLUE Analogue output carrying the blue colour values. (75 Ohm cable impedance).
4 NC No Connection
5-8 GND
9 5V This 5V supply is fused by a 1.1A resettable fuse.
10 GND
11 NC No Connection
12 DDCDAT Display Data Channel Data. Used as data signal to/from monitors with DDC interface.
13 HSYNC CRT horizontal synchronization output.
14 VSYNC CRT vertical synchronization output.
15 DDCCLK Display Data Channel Clock. Used as clock signal to/from monitors with DDC interface.
Page 30
Signal PIN
A0 RED 1
A0 GREEN 2
A0 BLUE 3
- NC 4
10
GND 5
IO-Area Connectors
Signal Type
6 GND PWR
11 NC -
GND PWR
7
12 DDCDAT IO
8 GND PWR
13 HSYNC O
9 5V PWR
14 VSYNC O
GND PWR
15 DDCCLK IO
KTQ67 Users Guide
Pull
Ioh/Iol Note
U/D
- -
- -
- -
TBD 2K2
- -
TBD
- - 1
TBD
- -
TBD 2K2