Removing The Fork Protector; Installing The Fork Protector; Removing The Lower Triple Clamp (Exc-R Six Days, Xcr-W Usa) - KTM 450 EXC-R EU Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Removing the fork protector

Installing the fork protector

Removing the lower triple clamp
x
Remove the fork legs. (
Remove screws
Remove the screws on the right fork leg. Remove the fork protector upwards.
500105-10
x
Check parts for damage and wear. Replace damaged or worn parts.
Position the fork protection on the left fork leg. Mount and tighten screws
Specification
Remaining screws, chassis
Position the fork protection on the right fork leg. Mount and tighten screws.
Specification
Remaining screws, chassis
Install the fork legs. (
500105-10
x
(EXC-R SIX DAYS, XCR-W USA)
Remove the fork legs. (
(XCR-W USA)
Dismount the start number plate. (
(EXC-R SIX DAYS)
Remove the headlight mask with the headlight. (
Dismount the front fender. (
Remove screws
Info
Do not unplug the CDI control unit.
Remove screw
and place it on one side.
Info
Protect the motorcycle and its attachments from damage by covering them.
500099-10
Do not bend the cables and lines.
Remove o-ring
Remove the lower triple clamp with the steering stem.
Remove the upper steering head bearing.
500100-10
P. 41)
on the left fork leg. Remove the fork protector upwards.
M6
M6
P. 42)
P. 41)
P. 47)
P. 46)
and hang the CDI control unit to the side.
. Remove screw , take off top triple clamp with the handlebar
. Remove protector ring .
43
.
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
P. 46)