A+ SERVER 2022TG-HTRF/HIBQRF User's Manual
Unpacking
The serverboard is shipped in antistatic packaging to avoid static damage. When
unpacking the board, make sure the person handling it is static protected.
Control Panel
Control Panel
Ethernet Ports
COM1 Port
VGA Port
6-2
Control Panel
The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the serverboard to provide you with system status indications. A
ribbon cable has bundled these wires together to simplify the connection. Connect
the cable from JF1 on the serverboard to the Control Panel PCB (printed circuit
board). Make sure the red wire plugs into pin 1 on both connectors. Pull all excess
cabling out of the airfl ow path. The LEDs inform you of system status.
See Chapter 3 for details on the LEDs and the control panel buttons. Details on
JF1 can be found in Chapter 5.
Figure 6-1. Front and Rear Chassis Views
SATA Drives (12)
IPMI LAN Port
USB Ports
6-2
Control Panel
Control Panel
Infi niband Port