Supero A+ SERVER 2022TG-HTRF User Manual page 52

I2C to PCI-Express Slot
JI C1/JI C2 allows you to enable the I
2 2
to communicate with the PCI-Express slot.
For the jumpers to work properly, please set
both jumpers to the same setting. If enabled,
both jumpers must be enabled. If disabled,
both jumpers must be disabled. See the table
on the right for jumper settings.
Watch Dog Enable/Disable
JWD enables the Watch Dog function, a
system monitor that takes action when a
software application freezes the system.
Jumping pins 1-2 will have WD reboot the
system if a program freezes. Jumping pins
2-3 will generate a non-maskable interrupt for
the program that has frozen. See the table
on the right for jumper settings. Watch Dog
must also be enabled in BIOS.
VGA Enable/Disable
JPG1 allows you to enable or disable the
VGA port. The default position is on pins 1
and 2 to enable VGA. See the table on
the right for jumper settings.
BMC Jumper
JPB is used to
theBMC (Baseboard Management Control)
Chip and the onboard IPMI connection.This
jumper is used together with the IPMI
settings in the BIOS. The default position
is on pins 1 and 2 to Enable BMC. See the
table on the right for jumper settings.
LAN1/2 Enable/Disable
Change the setting of jumper JPL1 to enable
to enable or disable the LAN1 and
LAN2 Ethernets ports. See the table on
the right for jumper settings. The default
setting is
enabled.
Chapter 5: Advanced Serverboard Setup
C bus
2
enable or disable
5-17
I 2 C to PCI-Express Slot
Jumper Settings
(JI2C1/JI2C2)
Jumper Setting Defi nition
Closed Enabled
Open Disabled
Watch Dog
Jumper Settings (JWD)
Jumper Setting Defi nition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
Note: when Watch Dog is enabled, the user
must write their own application software to
disable the Watch Dog Timer.
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
BMC Jumper Enable (JPB)
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Enabled (default)
Pins 2-3 Disabled
LAN1/2 En/Disable
Jumper Settings (JPL1)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled