A+ SERVER 2022TG-HTRF/HIBQRF User's Manual
SATA Hard Drive
2
2
Drive Tray
1. Install a new drive into the carrier with the printed circuit board side facing
down so that the mounting holes align with those in the carrier.
2. Secure the hard drive by tightening all six (6) screws.
3. Use the open handle to replace the drive tray into the chassis. Make sure the
close the drive tray handle.
Warning! Enterprise level hard disk drives are recommended for use in
!
Supermicro chassis and servers. For information on recommended HDDs,
visit the Supermicro Web site at
storage.cfm.
Figure 6-19. Installing the Hard Drive
6-18
1
2
http://www.supermicro.com/products/nfo/