US Cutter LaserPoint User Manual page 43

We are now done in the Printer screen so you can press the Finish button from the top menu boxes to
return to the main SignBlazer screen.
Follow the steps from the "Preparing the LaserPoint for Cutting" (page 20) section of this manual to get
your media loaded into your cutter and ready to cut. Make sure that the registration marks are aligned at
the left and right sides of the bottom edge of the print just as they were on the print screen of the
SignBlazer software.
Make sure that your cutter is on and in On Line mode before proceeding.
Now, back at the main screen of the SignBlazer software, select Cut A Print from the File drop down
menu to go to the Cut A Print screen.
- 42 -