Install Signblazer Software; Preparing The Laserpoint For Cutting - US Cutter LaserPoint User Manual

Expand the section labeled "Ports (COM & LPT)".
Make a note of which number COM Port is associated with "USB Serial Port".
You will need this information to properly install your software.

Install SignBlazer Software

Insert the SignBlazer Elements CD into your computer.
Select "Run Setup" .
Follow the on screen instructions.
When asked what cutter you want to use, select the USCutter LaserPoint.
When asked what port your cutter uses select the COM Port that corresponds with your setup (Noted
above from the "Finding Your COM Port" section of the manual).
Do not change the Baud Rate, Data Bits, Stop Bits, or Parity options.
Make sure the Flow Control option is set to Hardware.

Preparing the LaserPoint for Cutting

If you are going to be cutting from a roll of vinyl (or other material), and did not purchase a stand with your
LaserPoint cutter, then you may want to use the included table top rollers to hold the roll. The table top
rollers will work best if they are allowed to hang slightly over the edge of a table so that the hooks on the
cutter side are allowed to fully connect with the cutter, increasing stability.
If you are going to cut from a single sheet instead of a roll, then skip the next step on placing a vinyl roll. All other
steps will be the same.
- 20 -