US Cutter LaserPoint User Manual page 33

With the image selected, select "Monochrome – 1 bit" from the Mode section of the Image drop down
menu.
Sometimes an imported image will already be in monochrome but will still need to be vectorized before being cut. If the
image imported is monochrome than you can skip ahead to the "vectorise" section.
The "Convert Image to monochrome" window will appear.
Now you can adjust the Threshold Level slider. Where you place the slider will determine how much of
the image will be included in the monochrome conversion (which is to become the image that will be cut).
Anything darker than the level set on the Threshold slider will be included in the cut and anything lighter
will not.
- 32 -