Pressure Setting Mode - US Cutter LaserPoint User Manual

Pressure Setting Mode

The Pressure Setting Mode is used to adjust the pressure of the cutting blade.
Thicker materials can require more pressure. The pressure should be strong
enough to fully cut the top vinyl but not strong enough to cut through the
backing attached to your vinyl. If you are unsure of the cutting pressure that you
should use, it is advised to make a test cut. This can be done by holding the Test
Button in this mode or by returning to Jog Mode and pressing the Test Button.
You can see how the pressure effects the down cutting position of the blade by
returning to Jog Mode and using the Up/Down Buttons.
Test Button
On Line Button
Mode Button
Pause Button
Directional Buttons
Target Button
Up/Down Buttons
Plus/Minus Buttons
Returns the cutter to Jog Mode (If held down, a test cut
will be made).
(has no function in this mode).
Cycles through the 7 Off Line modes.
Returns the cutter to Jog Mode.
(has no function in this mode).
(has no function in this mode).
(has no function in this mode).
Increases/Decreases the amount of pressure used
when cutting (ranges from 0 to 200). Thicker materials
may require more pressure. The amount of pressure
used can be seen by going to the Jog Mode and using
the Up/Down buttons to switch the blade from the
original position to the Down cutting position.
- 9 -