Repeat Mode - US Cutter LaserPoint User Manual

Repeat Mode

Repeat Mode allows you to cut an exact duplicate of the last cut that was sent to
your cutter. The number of repeats made can be selected with the Plus/Minus
Buttons. When you are ready for the repeat cuts to be made, press the On Line
Button. Although some software allows you to jog (move) the cutter before cuts
are made, since you are bypassing the software by making a cut directly from
the cutter, no software adjustments will be accounted for. If the blade or vinyl
needs to be moved, please use the Jog Mode.
Test Button
On Line Button
Mode Button
Pause Button
Directional Buttons
Target Button
Up/Down Buttons
Plus/Minus Buttons
Returns the cutter to Jog Mode (If held down, a test cut
will be made).
Starts the Repeat function.
Cycles through the 7 Off Line modes.
Returns the cutter to Jog Mode.
(has no function in this mode).
(has no function in this mode).
(has no function in this mode).
Plus/Minus Buttons Increases/Decreases the
number of repeat cuts to be made. These will be a
repeat of the last cut that was sent to the cutter.
Once the On Line button is pressed, all of the cuts will be
made in succession.
- 11 -