Fixing The Infra-Red Eye - Flavel Kenilworth HE Installation, Maintenance & User Instructions

3.6 FIXING THE INFRARED SENSOR IN POSITION (Remote Control
Models)
a) Due to the large amount of different fascia's that can be supplied with
these fires, the infrared sensor is supplied from the factory attached to a
self adhesive pad. This pad can therefore be attached to the hearth or
fascia (Diamond HE models) in a position to suit the form of the fret or
contemporary trim assembly that is chosen with the product. Fig. 37
below shows the self adhesive pad and infrared eye attached to the
flying lead, as supplied from the factory.
Fig. 37
Infrared Eye Sensor
b) Remove the backing paper from the self adhesive pad and position the
infrared eye in the air channels in the ashpan cover, so that the infrared
eye is flush with the front edge of the ashpan cover, as shown below in
Fig. 38. Check the operation of the handset, as detailed in Section 3.3
and adjust the position of the infrared eye if necessary.
Fig. 38
Self Adhesive Pad
33
Infrared Eye
Flying Lead
Final position of
infrared eye