Lighting The Appliance (Slide Control Model) - Flavel Kenilworth HE Installation, Maintenance & User Instructions

f) Slightly depress the control knob and turn to the pilot position, the main
burner will go out but the pilot will remain lit.
g) Slightly depress the control knob and turn to the off position, the pilot
will now be extinguished.
WARNING : If the fire goes out for any reason or is turned off and it
isnecessary to re-light the fire it is important to allow the
fire to cool for 3 minutes before attempting to re-light it.
3.4 LIGHTING THE APPLIANCE (Slide Control Models)
a) Turn on the isolation valve. Depress the control lever fully downwards
to the position marked " Z". Hold down the control lever for a few
seconds to allow the gas to reach the pilot.
b) The fire will then begin its ignition sequence. If the pilot does not light,
continue to press the control lever until ignition occurs. The pilot flame
can be seen by looking underneath the front ceramic rail, above the
burner heat shield, at the front left hand side of the fuel. When the pilot
has lit, continue to hold the control lever down for 5-10 seconds to allow
the thermocouple to heat up, before releasing the lever apply one firm
downwards push to ensure that the f.s.d. valve is fully latched, if the
pilot goes out when the control lever is released, repeat the lighting
sequence.
c) After lighting, move control lever up to the high position and the main
burner will light. It is recommended that for the most efficient
performance the fire is allowed to warm up for 10 minutes with the
control lever set to high.
d) The gas control can be moved from the High to Low position to give the
desired heat output and the flame control adjusted to give the most
pleasing flame effect or maximum glow.
e) To turn the fire off, FULLY raise the control lever to the OFF position.
WARNING : If the fire goes out for any reason or is turned off and it
isnecessary to re-light the fire it is important to allow the
fire to cool for 3 minutes before attempting to re-light it.
31