Re-Assembling The Ceramics And Fuel Bed (Coal Models) - Flavel Kenilworth HE Installation, Maintenance & User Instructions

6.3 RE-ASSEMBLING THE CERAMICS AND FUEL BED - COAL
MODELS
NOTE : The position of the fuel-bed components are critical to the
performance of the product. Therefore please ensure that the fuel-bed
components are positioned as described in the following section prior to
requesting a service call due to soot build up, poor flame pattern etc.
a) Remove the glass panel and retaining trims as detailed on page 11 &
12. Place the ribbed ceramic fuelbed base on top of the fuelbed
support and pull fully forwards to the burner. Make sure that the
fuelbed base is located centrally in the fire box. Ensure that the
fuelbed base fit fully down onto the fuel bed support and is not
lodged on the burner. Ensure the air ports as indicated by the
arrows are not blocked by the fuel-bed matrix. See fig. 3 & 4
below.
Fig. 3
Fig. 4
Air ports in Fuelbed base mounting panel
Check air ports in fuel-bed base panel are not obstructed.
If these air ports are not in line with the holes in the fuel-
bed base matrix do not proceed with the installation
52