VENDAPIN DATATRON III SERIES 5882 Operator's Manual page 6

What's new in this release
Normal and Steering mode Operation
The firmware installed in your device determines the mode of operation you will be running. The
firmware version usually displays at power-up. You can also read it in idle state (ENTER
DATATRON PIN CODE) by simply pressing *. Your firmware version will display briefly. Make
a note of this in your manual, as you will need it if you need to call for support. The table below
shows how the firmware version relates to the features in your unit, which is chosen to match your
copier.
Version
4.11-1
4.12-1
4.13-1A
4.14-1A
4.11-2
4.13-2
Standard Mode uses
• An enable relay closure to allow the copy process to begin.
• A pulse back on Opto 1 from the copier indicates that a Price 1 copy has been completed.
• A pulse back on Opto 2 from the copier indicates that a Price 2 copy has been completed.
Steering Mode uses
• An enable relay closure to allow the copy process to begin.
• A pulse back on Opto 1 from the copier indicates that a copy has been completed.
• A steady low level on Opto 2 line indicates the copy is Price 1.
• A steady high level on Opto 2 line indicates the copy is Price 2.
Displayed Count/Price
(One) Count/Price
(Two) M-1 Master, P-1 Print
(Two) C-1 count, C-2 count
(Two) M-1 Master, P-1 Print
(One) Count/Price - STEERING MODE
(Two) C-1, C-2 – STEERING MODE
Accounts
2000
1000
1000
1000
2000
1000