VENDAPIN DATATRON III SERIES 5882 Operator's Manual page 31

Typical Print/Datatron III Configuration:
Steering Mode Configuration #1 Example
Typical Copier Configuration: (i.e.: Black & White multi-functional copier/printer)
Paper Sizes (in copier trays):
• Letter
• Legal
Toner Types
• Black & White
Copier Interface Signals:
Enable Signal from Datatron to Copier
• Input enable line to copier to allow the copier to run (normally open relay contact closure)
Price Data Signals from Copier to Datatron
• Vend pulse from copier to Datatron for all prices to Opto 1, indicating a copy has been
made.
• Paper size selection is based on copier signal level to Datatron Opto 2.
o Letter size selection (Pin 5 - 6 LOW or OFF)
Legal size selection (Pin 5 - 6 HIGH or ON)
o
9-Pin AMP Mate-n-Lok white connector pins on cable from back of Datatron III unit – connected
to copier interface paper size selection lines:
Enable Pins 1 & 2
Opto 1 Pins 3 & 4 – connected to vend pulse line
Opto 2 Pins 5 & 6 – connected to selection 1 line
Build matrix based on known selections as shown here for B & W copies only:
Opto 2 Paper
OFF Letter
ON Legal
Price Level Prices
1 0.10
2 0.15
Notes
Default to Letter
Legal