VENDAPIN DATATRON III SERIES 5882 Operator's Manual page 18

A b o u t m e t e r s
All vending activity is recorded by an extensive set of internal electronic meters.
• Master Count meter. Provides a tamper-proof record of all the counts made on the unit.
• Individual meters. Allow for periodic recording of transactions. All PIN accounts come
with one (or generally) two individual meters. Depending on your firmware, they may be a
Master or Copy pair or a Print Value 1 and Print Value 2 type count. They are usually
viewed, then reset with value on a regular basis.
1 . V i e w i n g a n d r e s e t t i n g m e t e r s o n t h e D a t a t r o n L C D d i s p l a y
You can view both total and individual meters directly on the display or upload them to a PC
using VENDAPIN's Datatron III CD. The manual keypad meter-reading technique is shown in
the table below.
When you first turn on the unit, it will be in standby mode, ready for user input, and display:
ENTER DATATRON PIN CODE
Insert the Control Card. The display will change to:
MACHINE
LOAD COMMAND:
Enter the menu Parameters as shown in the following table to control meters.
Using Meters