Jumper Settings - LanParty X58-T3EH6 User Manual

2
Hardware Installation

Jumper Settings

Clear CMOS Data
If you encounter the following,
a) CMOS data becomes corrupted.
b) You forgot the supervisor or user password.
c) The overclocked settings in the BIOS resulted to the system's in-
stability or caused system boot up problems.
you can reconfigure the system with the default values stored in the
ROM BIOS.
JP10 is accessible from the rear panel of the system. This provides
convenience by allowing you to clear the CMOS without having to
remove the chassis cover.
To load the default values stored in the ROM BIOS, please follow
the steps below.
1. Power-off the system then unplug the power cord.
2. Set JP2 or JP10 pins 2 and 3 to On. Wait for a few seconds
and set JP2 or JP10 back to its default setting, pins 1 and 2 On.
3. Now plug the power cord then power-on the system.
28
3
JP10
2
1
1-2 On: Normal
(default)
1 2 3
JP2
1
1-2 On: Normal
(default)
3
2
1
2-3 On:
Clear CMOS Data
1 2 3
2-3 On:
Clear CMOS Data