Table of Contents
Advertisement
Table 4.9. DVI-analog RGB conversion adapter
Connector type
C5
C4
C2
C3
C1
16
8
24
17
1
15.00
6.20
Pin No.
1
2
3
4
5
6
7
8
For the LCDs that can be connected, please refer to "Chapter 7 List of Options".
Display driver
Install the appropriate display driver for your OS from the CONTEC's Web site [IPC-SLIB-01].
(For information on the latest version of IPC-SLIB-01, check the CONTEC's Web site.)
CAUTION
-
You need to set the screen resolution if the display cable is not connected to this DVI-D interface at
OS startup, but connected after OS startup (hereinafter referred to as "Late Insertion").
-
When the analog display is used, Windows MS-DOS may not be properly displayed in full-screen
mode.
This is because the frequency and resolution of Windows and MS-DOS (full-screen display) are the
same due to the screen settings while the display parameters are different.
For display, as only one parameter can be stored for one frequency or resolution, only either of
Windows or MS-DOS screen can be displayed properly.
In this case, change the resolution or display frequency of Windows so that it is not the same as for
the MS-DOS display.
PT-955LXC-DC5311 User's manual
DVI-I 29 pin
30.00
Signal on analog RGB
Signal name
Pin No.
RED
GREEN
BLUE
N.C.
GND
GND
GND
GND
6
1
11
5
15
10
5.80
[mm]
Signal name
9
+5V
10
GND
11
N.C.
12
DDC DATA
13
HSYNC
14
VSYNC
15
DDC CLK
4. Each Component Function
29
Advertisement
Table of Contents
