Table of Contents
Advertisement
Overview
Rack-Mounting
the Provider Unit
40
To install the Provider unit in an AT-MCR12 rackmount chassis, perform
the following steps:
1. Configure the right VDSL CONFIG switch (SCBR/PROV) to the SCBR
position as shown in Figure 13 on page 39.
2. Attach the unit to one of the sliders that holds the unit in the chassis,
as shown in Figure 14.
Figure 14. Rack Mount - Set on Slider
3. Position the slider, as shown in Figure 15 and push into the chassis.
Figure 15. Rack Mount - Set in Rack
4. To connect the cables, see "Cabling the Provider Unit" on page 41.
1636
M C R 1 2
1939
PO W ER
Advertisement
Table of Contents
