Installing The At-Mc606 Vdsl Network Extender Subscriber Unit; Using The Subscriber Unit On A Desktop; Figure 7. Attaching Protective Feet; Figure 8. Configuring At-Mc606 Ethernet Extender For Subscriber Mode - Allied Telesis AT-MC606 Installation Manual

Overview

Installing the AT-MC606 VDSL Network Extender Subscriber Unit

Using the
Subscriber Unit
on a Desktop
34
The AT-MC606 Subscriber unit is normally used as a stand-alone device,
or can be used as a desktop device, or mounted to a wall.
To use the Subscriber unit on a desktop, perform the following procedure:
1. Remove all equipment from the package and store the packaging
material in a safe place.
2. Attach the four protective feet (provided) to each corner of the bottom
of the unit, as illustrated in Figure 7.

Figure 7. Attaching Protective Feet

3. Position the AT-MC606 on the desktop.
4. Configure the right VDSL CONFIG switch (SCBR/PROV) to the SCBR
position as shown in Figure 8.

Figure 8. Configuring AT-MC606 Ethernet Extender for Subscriber Mode

VDSL CONFIG
SCBR FAST ASYM 6dB
PROV INTL SYM 9dB
1936
1932