Table of Contents
Advertisement
Wall-Mounting
the Subscriber
Unit
Cabling the
Subscriber Unit
5. Go to "Cabling the Subscriber Unit" on page 35 to connect the cables
and to "Powering On the Subscriber Unit" on page 37 for powering the
unit.
The AT-MC606 VDSL Network Extender may be wall mounted directly to
the wall with an AT-WLMT Wall Mount Bracket or by using an Allied
Telesis DINRAIL Bracket (both supplied separately) in conjunction with a
previously mounted DINRAIL.
1. Configure the right VDSL CONFIG switch (SCBR/PROV) to the SCBR
position as shown in Figure 8, "Configuring AT-MC606 Ethernet
Extender for Subscriber Mode" on page 34.
2. Follow the installation instructions supplied with the wall mounting
bracket.
3. Go to "Cabling the Subscriber Unit" on page 35 to connect the cables
and to "Powering On the Subscriber Unit" on page 37 for powering the
unit.
To cable the Subscriber unit to a computer, perform the following steps:
1. Connect the Ethernet cable from the AT-MC606 Ethernet port to the
Ethernet port on your computer, as shown in Figure 9.
Figure 9. Connecting AT-MC606 Ethernet Port to Computer
AT-MC606 VDSL Network Extender Installation Guide
10 B as
e -T /
10 0B
as e- T
X
LN K /A
C T
10 0M
V D S L
C O N
SC B R
F IG
FA ST
P W R
A SY M
6d B
A T - M
C 6 0 6
PR O V
V D S L
IN TL
L IN E
SY M
V D S
9d B
L E X
T E N
D E D
E T H
E R N
E T
1937
S C B R
P R O V
L IN K
R A T E
35
Advertisement
Table of Contents
