Wall-Mounting The Subscriber Unit; Cabling The Subscriber Unit; Figure 8. Connecting At-Mc605 Ethernet Port To Computer - Allied Telesis AT-MC605 Installation Manual

Overview
Wall-Mounting
the Subscriber
Unit
Cabling the
Subscriber Unit
36
5. Go to "Cabling the Subscriber Unit" on page 36 to connect the cables
and to "Powering On the Subscriber Unit" on page 38 for powering the
unit.
The AT-MC605 VDSL Ethernet Extender may be wall mounted directly to
the wall with an AT-WLMT Wall Mount Bracket or by using an Allied
Telesis DINRAIL Bracket (both supplied separately) in conjunction with a
previously mounted DINRAIL.
1. Configure the right VDSL CONFIG switch (SCBR/PROV) to the SCBR
position as shown in Figure 7, "Configuring AT-MC605 Ethernet
Extender for Subscriber Mode" on page 35.
2. Follow the installation instructions supplied with the wall mounting
bracket.
3. Go to "Cabling the Subscriber Unit" on page 36 to connect the cables
and to "Powering On the Subscriber Unit" on page 38 for powering the
unit.
To cable the Subscriber unit to a computer or telephone, perform the
following steps:
1. To connect a computer to the AT-MC605 Ethernet Extender, connect
the ethernet cable from the AT-MC605 ethernet port to the ethernet
port on your computer, as shown in Figure 8 , "Connecting AT-MC605
Ethernet Port to Computer".

Figure 8. Connecting AT-MC605 Ethernet Port to Computer

10 B as
e- T /
10 0B
as e- T
X
LN K /A
C T
10 0M V D S L
C O N
SC B R
F IG
FA ST
P W R
N O LI
M IT
6d B
P H O N
E
A T - M
C 6 0 5 PR O V
IN TL
RA TE
LI M IT
V D S
9d B
L E X
T E N
D E D
E T H
E R N
E T
1558
V D S L
L IN E
S C B R
P R O V
LI N K
R A TE