Installing The At-Mc605 Vdsl Ethernet Extender Subscriber Unit; Using The Subscriber Unit On A Desktop; Figure 6. Attaching Protective Feet To The Subscriber Unit; Figure 7. Configuring At-Mc605 Ethernet Extender For Subscriber Mode - Allied Telesis AT-MC605 Installation Manual

Installing the AT-MC605 VDSL Ethernet Extender Subscriber Unit

Using the
Subscriber Unit
on a Desktop
The AT-MC605 Subscriber unit is normally used as a stand-alone device,
or can be used as a desktop device, or mounted to a wall.
To use the Subscriber unit on a desktop, perform the following procedure:
1. Remove all equipment from the package and store the packaging
material in a safe place.
2. Attach the four protective feet (provided) to each corner of the bottom
of the unit, as illustrated in Figure 6 , "Attaching Protective Feet to the
Subscriber Unit".
RATE
LINK
PROV
SCBR
LINE VDSL

Figure 6. Attaching Protective Feet to the Subscriber Unit

3. Position the AT-MC605 Ethernet Extender on the desktop.
4. Configure the right VDSL CONFIG switch (SCBR/PROV) to the SCBR
position as shown in Figure 7.

Figure 7. Configuring AT-MC605 Ethernet Extender for Subscriber Mode

AT-MC605 VDSL Ethernet Extender Installation Guide
ETHERNET EXTENDED
9dB LIMIT RATE INTL PROV
6dB LIMIT NO FAST SCBR
PHONE
CONFIG VDSL
VDSL CONFIG
SCBR FAST NO LIMIT 6dB
PROV INTL RATE LIMIT 9dB
1589
AT-MC605
VDSL
PWR
100M
LNK/ACT
100Base-TX
10Base-T/
1592
35