Connect the calibration mic to the
A.CAL MIC jack on the front panel and
press X/x to select [YES], then press
Set up the calibration mic at the ear level
using a tripod, etc. (not supplied). The front
of each speaker should face the calibration
mic, and there should be no obstruction
between the speakers and the calibration
mic. Be quiet during the measurement.
Connect calibration mic. Start
Auto Calibration starts.
• Loud test sound is output when [AUTO
CALIBRATION] starts. You cannot turn the
volume down. Give consideration to children
Downloaded From TheatreSystem-Manual.com Manuals
• Avoid being in the measurement area and
making noise during the measurement (which
takes about 3 minutes), as it may interfere with
Unplug the calibration mic and press C/
c to select [YES].
Quick Setup is finished. All connections
and setup operations are complete.
FRONT L :
FRONT R :
SURROUND L :
SURROUND R :
If OK, unplug calibration mic and select
• If measurement fails, follow the message then
retry [AUTO CALIBRATION].
To quit the Quick Setup
DISPLAY in any Step.
• If you change the position of the speakers, reset the
speaker settings. See "Getting Optimal Surround
Sound for a Room" (page 66) and "Calibrating the
Appropriate Settings Automatically" (page 68).
• If you want to change any of the settings, see "Using
the Setup Display" (page 70).
To recall the Quick Setup display
DISPLAY when the system is in
The Control Menu appears.
Press X/x to select
The options for [SETUP] appear.
1 2 ( 2 7 )
1 8 ( 3 4 )
Press X/x to select [QUICK], then press
The Quick Setup display appears.