Table of Contents
Advertisement
S
S
UPER
ERVER 5016I-MT/5016I-MTF User's Manual
Wake-On-Ring
The Wake-On-Ring header is des-
ignated JWOR. This function allows
your computer to wake up when
receiving an incoming call to the
modem when in the suspend state.
See the table on the right for pin
defi nitions. You must have a Wake-
On-Ring card and cable to use this
feature.
Wake-On-LAN
The Wake-On-LAN header is lo-
cated at JWOL on the motherboard.
See the table on the right for pin
definitions. (You must also have
a LAN card with a Wake-On-LAN
connector and cable to use this
feature.)
Unit ID Switch
There are three Unit Identifi cation
(UID) devices on the motherboard.
A rear UID switch and a rear UID
LED indicator. The Front Panel UID
LED is connected to a pin in the
Front Control Panel (Pin 7 of JF1).
When the user pushes the rear UID
switch, the Front Panel UID LED and
the backplane UID LED (LE5) will
turn on. Push the rear UID switch
again to turn off both Indicators.
These UID Indicators provide easy
identifi cation of a system unit that
may be in need of service.
Wake-On-Ring
Pin Defi nitions
Pin#
1
2
Wake-On-LAN
Pin Defi nitions
Pin#
1
2
3
Pin#
1
2
3
4
5-20
Defi nition
Ground
Wake-up
Defi nition
+5V Standby
Ground
Wake-up
UID Switch
Defi nition
Ground
Ground
Button In
Ground
Advertisement
Table of Contents
