Operator Panel Ground Cable Removal - Lexmark C746n Service Manual

Operator panel ground cable removal

Remove the top access cover assembly. See
1.
2. Turn the top access cover assembly over.
Remove the eight screws (A) securing the position guide cover.
3.
Disconnect the operator panel ground cable from the operator panel ground pin (B).
4.
Remove the screw (C) securing the operator panel ground cable to the operator panel card.
5.
Remove the operator panel ground cable from its retainers.
6.
Installation note: Pay attention to the routing of the ground cable.
"Top access cover assembly removal" on page
A
C
B
5026
4-54.
Repair information
4-133
Previous
Next
Go Back