Motor Calibration; Paper Prompts; Envelope Prompts; Action For Prompts - Lexmark C746n Service Manual

5026

Motor Calibration

This test is run to calibrate the leading edge of the paper to each transfer station.
Select Motor Calibration from the Configuration Menu.
1.
Calibrating displays, and the printer prints eight blank pages and then returns to the Configuration Menu.
2.
Note: This test should be run at 600 dpi resolution and with duplex disabled.

Paper Prompts

Controls the source the printer selects for a change paper source message. The printer displays the change
paper source message based on the size of the paper requested and not by the paper type.
Selections include Auto, Multi-Purpose Feeder, and Manual Paper.
Note: Multi-Purpose Feeder is only available on some printer models.
Note: If the Configure MP setting is changed to Manual, a power-on reset is performed, and the value of the
Paper Prompts menu item before the power-on reset was Multi-Purpose Feeder, then when the printer restarts,
the printer automatically changes the Paper Prompts setting to Manual Paper.
Load Manual overrides that would result in a change paper message are disabled for Paper or Envelope
prompts that are set to Manual, Manual Paper, or Manual Envelope.

Envelope Prompts

Controls the source the printer selects for a change envelope source message. The printer displays the change
envelope message based on the size of the envelope requested and not by the envelope type.
Selections include Auto, Multi-Purpose Feeder, and Manual Envelope.
Note: Multi-Purpose Feeder is only available on some printer models.
Note: If the Configure MP setting is changed to Manual, and a power-on reset is performed, and the value of
the Envelope Prompts menu item before the power-on reset was Multi-Purpose Feeder, then when the printer
restarts, the printer automatically changes the Envelope Prompt setting to Manual Envelope.
Load Manual overrides that would result in a change paper message are disabled for Paper or Envelope
prompts that are set to Manual, Manual Paper, or Manual Envelope.

Action for Prompts

This setting gives the user the option of having the printer resolve change prompt situations without requiring
any user assistance. If the Prompt user value is selected, the printer displays change prompts if the job does
not match the media in the selected source. The user must select another source or change the paper. If
Continue or Use current is selected, the printer acts as if the user made the selection Continue or
Use current and continues without user intervention, in most cases.

Jobs on Disk

Lets the user select whether or not the printer deletes all buffered jobs on the hard disk. This menu item only
appears if a hard disk is installed. It appears even if no buffered jobs exist on the hard disk.
Selections include Do Not Delete and Delete.
Note: Delete does not remove Print and Hold jobs. Use Remove Held Jobs in the Utilities Menu (user menu)
to delete these jobs.
Service Manual
3-32
Previous
Next
Go Back