Lexmark C746n Service Manual page 320

5026
Engage the gears (D) on the right side of the COD.
5.
6. Replace the five screws (E).
Verify the actuators can be seen by looking inside the printer at the triangular holes, as in step 2.
7.
Check to make sure you can rotate the large COD gear from stop to stop.
8.
Reconnect the cable connector to JBOR1 connector on the system board.
9.
Reinstall the top cover assembly, the fuser, and the covers.
10.
Service Manual
4-74
Previous
Next
Go Back