Lexmark C746n Service Manual page 366

5026
Installation note:
• When installing the new LVPS, make sure the voltage switch (A) is set for the proper value (115 V or
230 V), depending on the country.
Note: Not all LVPS FRUs have a switch. Others are switched automatically.
Install the LVPS, and make sure the AC fuser cable is in the cable guides, and not behind the LVPS.
•
Reconnect the AC fuser cable to the LVPS.
•
Replace the five LVPS mounting screws.
•
Reconnect the cable in connector JLVPS1 on the system board.
•
Service Manual
4-120
Previous
Next
Go Back