Table of Contents
Advertisement
5.2 How to Install lamp
Please see Illustration 1 -1 and 5-1/2.
1. Unscrew screws on the head with 8mm wrench.
2. Press the two safety levers at the same time and lift carefully the head plate.
3. Remove Sub-D socket by pressing the safety clips. Hang out the safety loop and
lift the head plate cautiously.
4. Remove the multiple pin strip 1 and 2.
5. Open the knurled screw of the Optical Slide.
6. Hang out the safety of the Optical Slide in.
7. Take out the Optical Slide in carefully.
8. Unscrew the M4 screw of the optical plate.
9. Open the upper part of the optical device.
10.Unscrew the HMI lamp nuts and change the lamp.
The lamp filler must be placed according to the illustration !!!
11.Close the
P
A
P
A
Attention: Make sure that the optical slide in fits in both grooves !!!
Illustration 5-2
T
E
N
D
-
L
I
G
H
T
1
2
0
0 in reverse order.
T
E
N
D
-
L
I
G
H
T
1
2
0
0
(V1.2)
17
Advertisement
Table of Contents
