Status Messages; Resetting The Machine After Fluid Out - Martin Jem Hazer Pro User Manual

Status messages

message












R e s e t t i n g t h e m a c h i n e a f t e r f l u i d o u t
If the machine runs out of fluid simply refill the fluid container and follow the
priming instructions on page 15.
24
reason
The heaters are Off, the unit is shut down.
The unit is heating up to operating temperature.
The heater is at operating temperature, but Haze is not turned
on (RUN set to STBY or HAZE set to 0%).
The heater is at operating temperature and the unit is under
DMX control.
The machine is in run mode and is producing haze.
The machine is in quiet run mode and is producing haze.
The machine is in Timer mode and is in a RUN period (the
number counts down to show the run time)
The machine is in Timer mode and is in an OFF period (the
number counts down to show the off time)
The machine has detected an error with its calibration settings
and will not operate. Call Martin Service.
The machine has detected an error in the temperature sensor
and will not operate. Call Martin Service.
The machine is running a cleaning cycle which lasts 90
seconds (number may be 90 to 0)
(on start-up) The internal battery is low and the last shutdown
did not complete. If this message displays on every start-up,
call Martin Service to obtain a replacement battery.
Status messages