Dmx Control; Overview; Connection; Dmx Functions - Martin Jem Hazer Pro User Manual

DMX control

O v e r v i e w
DMX is a digital control system widely used in entertainment and architectural
lighting. Any controller meeting the DMX-512 standard may be used to control
and program the haze output of the Jem Hazer Pro™.
C o n n e c t i o n
The Jem Hazer Pro™ provides 3-pin and 5-pin XLR connectors on the rear panel
of the unit for DMX connection.
You can use either the 3-pin or 5-pin connectors for in or link through, but you
should not use the unit as a splitter by connecting both the 3-pin and 5-pin
outputs.
For best results, use cable designed for high speed digital data transmission.
Suitable DMX cable is available from your Martin dealer.
D M X f u n c t i o n s
The Jem Hazer Pro™ address setting must match the DMX address allocated to it
on your controller. To set the address, see "Setting the DMX base address" on
page 15. The Jem Hazer Pro™ requires three DMX channels.
For example if the Jem Hazer Pro™ is set to DMX address 100, channel 1 will be
controlled by address 100, channel 2 will be controlled by address 101 and
channel 3 by address 102.
When the machine is at running temperature and is under DMX control it displays
.
The functions of each DMX control channel are shown on the following page.
When a DMX signal is present, the Jem Hazer Pro™ stand-
alone functions do not work. To fire the unit from the
control panel or remote control, the DMX controller must
be powered off or disconnected.
DMX control 19