Controls And Features; Maintenance - Zephyr AK 7500 series Use, Care And Installation Manual

CONTROLS & FEATURES
CONTROLS & FEATURES
AUTO MANUAL
6 Speed Level Indicator
2
Manual Mode Speed Selection
The control features on this range hood are touchless; to activate simply position your
finger approximately 1/4" in front of the selected switch. Activation time 0.5 - 1 second
Blower On/Off
1
By pressing , the blower is switched On and Off. When switched on, the blower starts up on
AUTO
speed level 6 in auto mode , and will automatically adjust the fan speed accordingly.
AUTO
While in auto mode , the manual mode
AUTO
still manually change speeds by selecting the + or - controls. The hood will automatically change
speeds as the temperature varies.
Delay Off Mode
If the range hood was in auto mode AUTO
the hood will go into delay off mode. After a 5 minute minute countdown in delay off mode,
the hood will shut down completely.
2 Manual Mode Speed Selection
Selecting + or - overrides all auto mode controls and activates manual mode
3 Lights On/Off/Dim
Switch lights On by selecting this switch. To Dim lights, activate
more time, will turn lights off.
Should you wish to manually turn off the touchless control for cleaning or safety, an electric toggle
switch is located to the right of the lights behind the controls. Toggle between I (on) or
Auto Mode Indicator
Manual Mode Indicator
Lights On/Off Indicator
Delay Off Indicator
1 Blower On/Off
3
Lights On/Off/Dim
indicator icon will flash indicating that you can
MANUAL
and the temperature has not changed for 5 minutes,
MANUAL
again. Selecting
Models: AK7500, AK7536, AK7548 Page 7
CLEANING
Surface Maintenance:
Clean periodically with hot soapy water and clean cotton cloth. Do not use corrosive or abrasive
detergent (e.g. comet powder scrub, EZ-Off oven cleaner), or steel wool/scoring pads which will
scratch and damage surface.
For heavier soil use liquid degreaser such as 'Formula 409' or 'Fantastic' brand cleaner.
After cleaning, you may use non abrasive stainless steel polish/ cleaners such as 3M or ZEP,
to polish and buff out the stainless luster and grain. Always scrub lightly, with clean cotton cloth,
and with the grain.
Stainless Steel Baffle Filters
The stainless steel baffle filters fitted by the factory are intended to trap residue and grease from
cooking. Although the filters never need replacement, they are required to be kept clean after
approximately every 30 hours of use.
as indicated.
one
Removing Baffle Filters
1. Pull filter toward back of range hood using handles.
2. Pivot filter front upward.
0
(off).
3. Remove downwards to the rear.

MAINTENANCE

2
Models: AK7500, AK7536, AK7548 Page 8
1
3