Preparing The Machine For Operation - Primus C 6 Installation And Maintenance Manual

WATER DRAIN CONNECTION
The machine is equipped with drain valve or optional with pump.
– for the machine equipped with drain valve; connect the drain pipe to the drain valve by means of included
clamp. The main drain pipe must have the capacity to be able to handle the total output of all connected
machines.
– for the machine equipped with drain pump; connect the end of the drain hose to a siphon or via a wash -
basin / sink. The hose must be laid out without kinks. The end of the hose must be not higher than
100 cm / 39" above floor level.
AIR VENT CONNECTION
WARNING !
!
WATCH OUT, VAPOURS ESCAPE FROM THE MACHINE THROUGH THE AIR VENT OPENING!
DO NOT COVER OR CONNECT TO ANYTHING!
On the backside, the washers are provided with an air vent opening of O.D. 76 mm / 3", fig. 3.1., pos. 9.
Do not cover the washer air vent opening. It is part of the back flow prevention water system. It also takes
care that the tub can not be pressurized by water intake and vapor of the hot water, this allows for proper
measuring of the water level.
For the safety of everyone make sure that unauthorized persons cannot reach the backside of the machine.

4.6. PREPARING THE MACHINE FOR OPERATION

CHECKING BEFORE PUTTING INTO SERVICE
1. Make sure the transporting braces are removed.
2. Put out all things from wash drum.
3. Check the machine horizontal position.
4. Check connection and clearance of your drain, channel or central drainage.
5. Check earthing and electrical supply connection.
6. Open water valves to machine and check hose and connections for leaks.
7. Read carefully the „User´s manual" and „Programming manual", which are a part of delivery.
8. Put the electrical plug into the wall socket.
9. Initialize the programmer after machine installation.
10 INSTALLATION AND MAINTENANCE MANUAL PUBLICATION DATE Jan 06 516574