Battery Switch - Regal 2300 Owner's Manual

CHAPTER 4
DC Circuit Protection
As part of the direct current circuitry (DC for short) the engine features
a breaker with a reset button. This breaker protects the engine wiring
from overloads. Refer to the engine manufacturer's manual for the
breaker location and operation.
In addition, there are fuses protecting the individual switches located
under the helm accessible at the port bow backrest or found under
the dash itself. See page 11. Always fi nd the reason a breaker or fuse
fails and repair the problem before replacing the parts. Replace with
the same amperage and type breaker or fuse. Carry extra ones which
are available at marine supply stores or your closest Regal dealer's parts
department.

Battery Switch

automatic bilge pump fl oat switch and stereo memory are wired directly
to the battery switch you can leave the vessel and still have the vessel
bilge pump energized with the battery switch in the "off " position along
with the stereo retaining its pre-set functions and stations.
Main DC Breaker
Near the battery switch are several electrical components. One of the
items is a breaker normally 50/60 amps with a red reset button. This
breaker protects the main red power lead running up to the dash.
4-10
The battery switch displays 2 functions; off and on.
Turn the knob to the "on" position before cranking
over the engine. Never turn the battery switch to
the "off " position with the engine running.
The battery switch is located under the rear bench
seat on the starboard side of the cockpit. Since the