Installing Car Seat On Base - Peg-Perego PRIMO VIAGGIO 4-35 Owner's Manual

Installing the Car Seat on the Base
It is recommended to adjust the
handle so that it rests at the top
edge of the car seat as shown.
To rotate the handle, press the squared
buttons (located on each side of the
handle where it attaches to the seat) and
rotate it to the recommended position (b).
To remove the car seat, move the handle
to the upright position. Place your hand
on the top of the seat back and pull up
on the release lever with your fingers (c).
Note: Pulling near the center of the lever
provides the easiest release.
- 33 -