Massage Program Table; Application; Procedure For Programs Tens 1–7/Ems 1–27/Massage 1–10; Advice On Application - Sanitas SEM 43 Instructions For Use Manual

Prog. Reasonable areas of application
No. Indications
19 Toning of upper limbs
20 Strengthening of upper limbs
21 Shaping of upper limbs
22 Increasing size of upper limbs
23 Toning of hips and thighs
24 Strengthening of hips and thighs
25 Toning of gluteal muscles
26 Strengthening of gluteal muscles
27 Shaping of gluteal muscles

6.5 MASSAGE program table

Prog. Reasonable areas of application
No. Indications
1 Muscle strain relief
2 Relaxing massage
3 Invigorating massage
4 Tapping massage
5 Tapping and jet massage
6 Vibrating massage
7 Warm up massage 1
8 Warm up massage 2
9 Pressure massage
10 Kneading and pressure massage
Electrodes must be placed so that they surround the muscle segments in questi-
on. For optimal effect, electrode distance must not be greater than approx. 15 cm.
Possible Phase Running
electrode time
position ( minutes)
1 20
12 – 17
2 10
1 20
12 – 17
2 10
1 20
12 – 17
2 20
1 15
12 – 17
20, 23, 24 1 20
2 10
20, 23, 24 1 20
2 10
22 1 20
2 10
22 1 20
2 10
22 1 20
2 20
Phase Running time
( minutes)
1 20
1 25
1 20
1 15
1 15
1 20
1 20
1 10
1 20
1 20
The electrodes should not be applied to the anterior wall of the thorax, i.e. never
massage the left or right large pectoral muscle.

7. Application

7.1 Advice on application

• If the machine is not used within 2 minutes, it switches off automatically (au-
tomatic switch-off function). When the unit is switched on again, the LCD
screen displays the menu selection and the most recently used menu flashes.
• If an admissible key is pressed, there is one short beep. If an inadmissible
key is pressed, there are two short beeps.
7.2 Procedure for programs TENS 1–7, EMS 1–27 and
MASSAGE 1–10 (quick start)
• Select a suitable program from the program tables (p. 22–23).
• Place the electrodes on the desired area for treatment (for positioning sug-
gestions see electrode positions, p. 2) and connect them to the device.
Selecting a program
• Press the ON/OFF button
• Using the M button, navigate through the menus
/ (Fig. 1, Example TENS display) and
confirm your selection with the E button.
• Using the UP/DOWN buttons, select the desired program and
confirm your selection with the E button (Fig. 2, Example TENS
program 03).
General information
If you wish to return to the previous selection menu, press the M
button. By holding down the E button, you can skip individual set-
ting steps and start directly with the stimulation treatment.
Setting the impulse intensity
At the start of stimulation treatment, the impulse intensity of
is set to 00 as default. No impulses are sent to the electrodes yet.
• Using the INTENSITY SETTING buttons, select the desired
impulse intensity. The impulse intensity display is adjusted
accordingly (Fig. 3). The impulse intensity of
can be set individually.
23
to switch on the device.
/
and
Fig. 1
Fig. 2
and
Fig. 3