Unit Description; Start-Up - Sanitas SEM 43 Instructions For Use Manual

4. Unit description

Buttons:
1 ON/OFF button
2 E button (Enter)
3 Intensity setting buttons (
+/- +/-
right)
4 Keylock
5 Selection button UP and DOWN
6 M button (Menu)
Display (full screen):
1 Menu / /
2 Low battery
3 Keylock
4 Timer function (remaining time display) or
working time
5 Frequency display (Hz), pulse width (μs) or
pause time
6 Impulse intensity channel 1 (
7 Impulse intensity channel 2 (
8 Operating status display
9 Program number
Accessories:
• 2x connection cable
• 4x adhesive elec-
trodes (45 x 45 mm)
• 1x belt clip
Key functions
Every time a key is pressed,
this is acknowledged by a signal tone in order to ensure that any unintentional
pressing of a key is detected. This signal tone cannot be switched off.
+/- +/-
left,
1
2
3
1
2
3
4
5
6
)
)
ON/OFF
(1) Press briefly to switch the device on.
(2) Press once to interrupt stimulation treatment.
(3) Hold ON/OFF key down (approx. 2 seconds) to switch off the machine.
UP and DOWN
Choice of treatment program, treatment time, frequency, pulse width, working
time and pause time.
4
M (Menu)
5
(1) Navigation between
6
(2) Return to program selection screen or menu selection.
E (Enter)
(1) Menu selection.
(2) To confirm a selection made with UP/DOWN, apart from channel intensity.
Intensity setting buttons (
Setting pulse intensity.
Keylock
Locks the buttons to avoid them being pressed unintentionally.
(1) To activate the keylock, hold down the
9
visible in the display (approx. 3 seconds).
(2) To deactivate the keylock, hold down the
8
disappears from the display (approx. 3 seconds).
7

5. Start-up

1. Remove the belt clip from the machine, if attached.
2. Press the battery compartment cover on the rear of the device
and slide it downwards.
3. Insert three AAA 1.5 V alkaline batteries. Make absolutely
sure that you insert the batteries with the correct polarity as
marked.
4. Replace the battery cover carefully (Fig. 1).
5. Reattach the belt clip, if required.
6. Attach the connecting cable to the electrodes (Fig. 2).
The electrodes have a clip fastener to ensure easy
connection.
20
, and menus.
+/- +/- +/- +/-
left, right)
button until the
button until the
symbol is
symbol
Fig. 1
Fig. 2