Advertisement
6
WIRE HARNESS CONNECTIONS- STEERING COLUMN, continued
11. Loosely secure the remote start harness to the left side of the
steering column harness using (2) supplied tie wraps. Verify mo-
bility of the steering column by moving the tilt and telescoping
features of the steering column making sure that the remote start
harness and ignition connector is placed so that it will not inter-
fere or come into contact with any of the moving parts.
12. Once clearance is achieved the harness can be tightly secured
with the tie wraps. Once tightened test steering column mobility
again to insure clearance.
NOTE: IT IS EXTREMELY IMPORTANT THAT THE REMOTE START HARNESS
IS SECURED TO THE FACTORY WIRE HARNESS ON THE LEFT SIDE OF
THE STEERING COLUMN HARNESS TO ALLOW FOR REASSEMBLY OF THE
STEERING COLUMN SHROUD. (FIGURE DD)
13. Locate the white 17-way multifunction switch connector on the left side of the steering column.
14. Carefully remove 2-3 inches of the covering on the factory harness and locate the wire listed
below.
15. Place one of the supplied IDC wire taps on to the vehicle wire (using the side of the IDC wire tap
that is open on both ends).
16. Insert the wire from the remote start harness in to the other side of the IDC wire tap and crimp in
place with pliers. (FIGURE GG)
REMOTE START HARNESS
RED/WHITE WIRE-PARKING LIGHT OUTPUT
VEHICLE WIRE
RED/WHITE WIRE
FIGURE GG
9
FIGURE FF
L/Y
L/O
W/R
B/Y
R/W
L/G
VIEW FROM HARNESS SIDE
1030832 Rev.A 10/05
B/R
W/B
G/W
Advertisement
