Advertisement
4
REMOTE START CONTROL MODULE PREPARATION
1. Insert the supplied fuses into the remote start control module as shown in below (FIGURE R).
The fuses fit tight so use a tool handle to seat them in place if necessary.
2. Install DNA card into the remote start control module as shown below. (FIGURE S)
3. Plug the supplied wire harness 10-way and 24-way and connectors into the remote start control
module (FIGURE T). Make sure the harnesses are seated completely.
4. Plug the supplied immobilizer interface 4-way connector into the remote start control module.
(FIGURE T)
NOTE: TAPE OFF THE WHITE WIRE (IF EQUIPPED) COMING FROM THE 4-WAY CONNEC-
TOR (THIS WIRE IS NOT USED ON THIS SYSTEM).
DOME LIGHT
TRUNK RELEASE
HVAC 1
HVAC 2
FIGURE R
5
REMOTE ENGINE START MODULE AND IMMOBILIZER INTERFACE MOUNTING
REMOTE ENGINE START MOUNTING, VEHICLE'S EQUIPPED WITH I-4 ENGINE
1. Route the 2-pin dipole antenna connector (previously installed in step 2) to the remote engine
start control module and plug into the 2-pin port on the back side of the module.
2. Find the black TCM module mounted against the bulkhead (over the clutch hole knockout)
secured with a silver mounting bracket to the left of the brake pedal.
3. Using (3) of the supplied long tie wraps secure the remote start control module to the TCM
module fastening the tie wraps around the upper and lower legs of the bracket which are
pointed out below (FIGURE U & V) by the arrows.
a. The remote engine start module wiring should run out towards the driver's side door.
NOTE: Make sure the remote start control module is securely mounted on the TCM module so
that it does not rattle and the remote start module connectors are facing towards the driver's
door. The harness should then be routed towards the driver's kick panel area as shown below
and secured to existing vehicle wiring using (1) supplied tie wrap. (FIGURE W).
FIGURE U
PK LIGHTS
DOOR LOCKS
MAIN B+
IGNITION
FIGURE S
FIGURE V
FIGURE T
5
FIGURE W
1030832 Rev.A 10/05
Advertisement
