Advertisement
10
REASSEMBLY, continued
4. Re-install the driver's side kneeblocker panel with the (4) phillips screws. (FIGURE SS)
5. Re-install the driver's side lower dash panel.
a. Plug the trunk release connector into the switch on the panel (sedan only) and carefully snap
the driver's side dash panel into place.
b. Secure the (2) 8mm bolts that secure the dashboard panel at the hood release.
(FIGURE TT)
c. Re-install the hood release handle.
FIGURE SS
11
SYSTEM POWER-UP
1. Verify that all connections are secure as per installation instructions.
2. Turn the ignition key to the RUN position.
3. Reconnect the negative battery terminal.
4. Turn the ignition key to the OFF position.
5. VERY IMPORTANT - USING THE IGNITION KEY, TURN THE IGNITION TO THE ON POSITION
THEN CRANK ENGINE UNTIL IT STARTS ONE TIME THEN SHUT THE VEHICLE OFF.
12
UNDERHOOD WARNING LABEL MOUNTING
1. Open the engine hood and find a suitable mounting location in the engine compartment that will be in plain sight when
the hood is open (on the radiator cowl).
2. Using an alcohol pad, clean the mounting surface thoroughly.
3. Remove the backing on the underhood sticker and mount in place.
4. Close hood.
FIGURE TT
13
1030832 Rev.A 10/05
Advertisement
